EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5JWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1751693751	189 Count	468 Count	124 Count
1751691951	186 Count	457 Count	122 Count
1751688349	177 Count	435 Count	118 Count
1751686555	171 Count	423 Count	116 Count
1751684755	166 Count	410 Count	114 Count
1751682954	163 Count	398 Count	112 Count
1751681154	158 Count	386 Count	110 Count
1751679353	155 Count	374 Count	108 Count
1751677552	150 Count	362 Count	106 Count
1751675751	147 Count	348 Count	104 Count
1751673951	143 Count	337 Count	102 Count
1751672150	139 Count	325 Count	100 Count
1751670349	136 Count	313 Count	98 Count
1751668549	131 Count	302 Count	96 Count
1751666748	127 Count	293 Count	94 Count
1751664956	119 Count	284 Count	92 Count
1751663156	115 Count	270 Count	89 Count
1751661355	109 Count	243 Count	86 Count
1751659554	103 Count	213 Count	81 Count
1751657754	81 Count	171 Count	61 Count
1751655953	57 Count	125 Count	39 Count
1751654152	33 Count	79 Count	16 Count
1751652351	28 Count	68 Count	14 Count
1751650550	25 Count	60 Count	12 Count
1751648750	20 Count	51 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)