EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1773882121	11 Count	234 Count	8 Count
1773880620	8 Count	189 Count	6 Count
1773879120	5 Count	114 Count	4 Count
1773877617	2 Count	50 Count	2 Count
1773874618	83 Count	991 Count	48 Count
1773873115	81 Count	965 Count	47 Count
1773871617	78 Count	938 Count	45 Count
1773870116	76 Count	911 Count	44 Count
1773868614	73 Count	869 Count	42 Count
1773865020	61 Count	772 Count	37 Count
1773863520	59 Count	745 Count	36 Count
1773862018	57 Count	715 Count	35 Count
1773860518	54 Count	676 Count	33 Count
1773859017	51 Count	648 Count	31 Count
1773857514	49 Count	622 Count	30 Count
1773856015	46 Count	587 Count	28 Count
1773854515	44 Count	559 Count	27 Count
1773853012	42 Count	527 Count	26 Count
1773851514	39 Count	496 Count	24 Count
1773850013	37 Count	440 Count	23 Count
1773848510	34 Count	407 Count	21 Count
1773847011	31 Count	329 Count	19 Count
1773845511	20 Count	245 Count	9 Count
1773843417	14 Count	196 Count	9 Count
1773841916	12 Count	168 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)