EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1761380274	84 Count	132 Count	72 Count
1761378473	82 Count	129 Count	71 Count
1761374872	75 Count	120 Count	66 Count
1761373072	68 Count	110 Count	60 Count
1761371271	48 Count	80 Count	41 Count
1761369470	40 Count	65 Count	34 Count
1761367671	28 Count	44 Count	23 Count
1761365869	24 Count	37 Count	20 Count
1761364068	19 Count	30 Count	16 Count
1761362268	15 Count	23 Count	13 Count
1761360467	6 Count	13 Count	5 Count
1761358667	3 Count	7 Count	3 Count
1761355065	662 Count	999 Count	518 Count
1761351464	654 Count	986 Count	512 Count
1761347863	646 Count	973 Count	506 Count
1761342461	633 Count	953 Count	496 Count
1761340661	629 Count	946 Count	493 Count
1761338860	620 Count	934 Count	485 Count
1761322681	579 Count	877 Count	457 Count
1761295672	491 Count	750 Count	384 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)