EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3OPF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3OPF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1747121949	140 Count	240 Count	76 Count
1747121049	138 Count	239 Count	75 Count
1747120148	137 Count	239 Count	75 Count
1747118347	133 Count	237 Count	73 Count
1747117446	131 Count	232 Count	72 Count
1747116545	130 Count	229 Count	72 Count
1747115645	128 Count	224 Count	71 Count
1747114744	127 Count	221 Count	71 Count
1747113843	125 Count	217 Count	70 Count
1747112943	124 Count	213 Count	70 Count
1747111157	114 Count	201 Count	66 Count
1747110257	111 Count	196 Count	64 Count
1747109356	109 Count	192 Count	63 Count
1747108455	106 Count	185 Count	61 Count
1747107554	102 Count	168 Count	58 Count
1747106653	99 Count	162 Count	56 Count
1747105753	96 Count	147 Count	54 Count
1747104852	93 Count	142 Count	52 Count
1747103951	89 Count	134 Count	49 Count
1747103051	86 Count	130 Count	47 Count
1747102150	83 Count	125 Count	45 Count
1747101249	80 Count	121 Count	43 Count
1747100348	78 Count	118 Count	42 Count
1747099448	75 Count	114 Count	40 Count
1747098547	73 Count	111 Count	39 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)