EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777792735	22 Count	72 Count	16 Count
1777790942	12 Count	40 Count	11 Count
1777789141	227 Count	1035 Count	189 Count
1777787340	217 Count	997 Count	180 Count
1777785540	209 Count	962 Count	173 Count
1777783739	196 Count	921 Count	162 Count
1777781938	184 Count	876 Count	152 Count
1777780137	173 Count	830 Count	143 Count
1777778337	165 Count	787 Count	136 Count
1777776536	158 Count	747 Count	130 Count
1777774735	150 Count	699 Count	123 Count
1777772934	141 Count	654 Count	115 Count
1777771134	134 Count	611 Count	109 Count
1777762138	94 Count	429 Count	78 Count
1777756736	77 Count	347 Count	64 Count
1777754935	70 Count	316 Count	58 Count
1777753134	65 Count	287 Count	54 Count
1777751333	60 Count	247 Count	50 Count
1777749533	56 Count	216 Count	47 Count
1777747740	45 Count	180 Count	41 Count
1777745939	34 Count	143 Count	31 Count
1777744138	29 Count	117 Count	27 Count
1777742338	19 Count	79 Count	18 Count
1777740537	13 Count	43 Count	13 Count
1777738736	332 Count	1006 Count	280 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)