EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1777809693	72 Count	335 Count
1777806090	67 Count	317 Count
1777802487	55 Count	297 Count
1777798884	50 Count	273 Count
1777795281	45 Count	248 Count
1777791678	40 Count	226 Count
1777788075	35 Count	196 Count
1777784472	30 Count	167 Count
1777780869	25 Count	139 Count
1777777266	20 Count	115 Count
1777773699	15 Count	91 Count
1777770096	10 Count	66 Count
1777766493	4 Count	35 Count
1777762890	211 Count	1023 Count
1777759287	206 Count	988 Count
1777755684	201 Count	960 Count
1777752081	197 Count	927 Count
1777748478	192 Count	898 Count
1777744875	187 Count	876 Count
1777741272	183 Count	853 Count
1777737669	179 Count	825 Count
1777734066	174 Count	794 Count
1777730501	172 Count	764 Count
1777726898	167 Count	740 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)