EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769954188	2 Count	569 Count
1769952388	1 Count	400 Count
1769950572	0 Count	191 Count
1769948760	6 Count	1038 Count
1769946942	4 Count	815 Count
1769945130	3 Count	618 Count
1769943313	2 Count	453 Count
1769941512	1 Count	384 Count
1769939695	0 Count	180 Count
1769937996	6 Count	1156 Count
1769936180	5 Count	968 Count
1769934369	4 Count	794 Count
1769932558	3 Count	618 Count
1769930740	1 Count	433 Count
1769928940	0 Count	186 Count
1769927128	6 Count	1056 Count
1769925314	5 Count	862 Count
1769923504	4 Count	662 Count
1769921693	3 Count	459 Count
1769919892	1 Count	208 Count
1769918081	0 Count	0 Count
1769916350	4 Count	887 Count
1769914542	3 Count	698 Count
1769912723	2 Count	510 Count
1769910923	0 Count	259 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)