EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP9DRM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DRM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1749189286	258 Count	54 Count	42 Count
1749187486	257 Count	54 Count	42 Count
1749185685	256 Count	54 Count	42 Count
1749183886	255 Count	53 Count	42 Count
1749182086	254 Count	52 Count	42 Count
1749180285	253 Count	51 Count	42 Count
1749178484	252 Count	50 Count	42 Count
1749176686	251 Count	50 Count	42 Count
1749174886	250 Count	49 Count	42 Count
1749173085	249 Count	48 Count	42 Count
1749171285	248 Count	47 Count	42 Count
1749162282	243 Count	47 Count	42 Count
1749160482	242 Count	47 Count	42 Count
1749158682	241 Count	47 Count	42 Count
1749156881	240 Count	47 Count	42 Count
1749147882	235 Count	47 Count	42 Count
1749146081	233 Count	46 Count	41 Count
1749144280	232 Count	46 Count	41 Count
1749142480	231 Count	46 Count	41 Count
1749140682	230 Count	46 Count	41 Count
1749138881	229 Count	46 Count	41 Count
1749137081	228 Count	46 Count	41 Count
1749128079	223 Count	44 Count	41 Count
1749126281	222 Count	44 Count	41 Count
1749124480	221 Count	44 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)