EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773886742	290 Count	643 Count	72 Count
1773885541	287 Count	614 Count	71 Count
1773884940	285 Count	605 Count	70 Count
1773884339	284 Count	590 Count	70 Count
1773883738	281 Count	576 Count	68 Count
1773883138	279 Count	561 Count	67 Count
1773882537	277 Count	549 Count	66 Count
1773881935	274 Count	529 Count	64 Count
1773880733	270 Count	503 Count	62 Count
1773880133	267 Count	485 Count	60 Count
1773879532	265 Count	470 Count	59 Count
1773878330	262 Count	431 Count	58 Count
1773877730	260 Count	423 Count	57 Count
1773877129	259 Count	410 Count	57 Count
1773876528	256 Count	396 Count	55 Count
1773875927	254 Count	383 Count	54 Count
1773875326	252 Count	372 Count	53 Count
1773874725	250 Count	356 Count	52 Count
1773874125	248 Count	347 Count	51 Count
1773873524	246 Count	337 Count	50 Count
1773872923	243 Count	324 Count	48 Count
1773872322	241 Count	318 Count	47 Count
1773871749	235 Count	305 Count	46 Count
1773870548	231 Count	294 Count	44 Count
1773869947	230 Count	292 Count	44 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)