EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1756291741	44 Count	109 Count
1756289935	42 Count	95 Count
1756288129	40 Count	95 Count
1756286323	38 Count	95 Count
1756284517	36 Count	95 Count
1756282710	34 Count	95 Count
1756280904	32 Count	95 Count
1756279098	30 Count	95 Count
1756277364	28 Count	90 Count
1756275557	26 Count	84 Count
1756273752	24 Count	78 Count
1756271946	22 Count	72 Count
1756270140	20 Count	66 Count
1756268334	18 Count	60 Count
1756266528	16 Count	55 Count
1756264722	14 Count	49 Count
1756262916	12 Count	43 Count
1756261110	10 Count	37 Count
1756259304	8 Count	31 Count
1756257498	6 Count	25 Count
1756255765	4 Count	15 Count
1756253958	2 Count	9 Count
1756252152	0 Count	3 Count
1756250346	276 Count	998 Count
1756248541	274 Count	992 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)