EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9BBC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9BBC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753514196	517 Count	596 Count	207 Count
1753513295	515 Count	584 Count	206 Count
1753512394	508 Count	570 Count	203 Count
1753511493	506 Count	566 Count	202 Count
1753510592	502 Count	553 Count	201 Count
1753509691	500 Count	542 Count	200 Count
1753508790	495 Count	533 Count	199 Count
1753507889	493 Count	519 Count	198 Count
1753506988	489 Count	505 Count	196 Count
1753506087	487 Count	496 Count	195 Count
1753505186	483 Count	481 Count	193 Count
1753504285	481 Count	470 Count	192 Count
1753503384	477 Count	468 Count	191 Count
1753502483	475 Count	465 Count	190 Count
1753501582	472 Count	464 Count	189 Count
1753500681	470 Count	462 Count	188 Count
1753499780	467 Count	458 Count	187 Count
1753498880	465 Count	457 Count	186 Count
1753497979	460 Count	454 Count	184 Count
1753497078	458 Count	453 Count	183 Count
1753496176	453 Count	451 Count	181 Count
1753495275	451 Count	450 Count	180 Count
1753494374	446 Count	448 Count	178 Count
1753493473	444 Count	447 Count	177 Count
1753492572	441 Count	446 Count	176 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)