EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777792205	807 Count	611 Count	458 Count
1777791301	804 Count	609 Count	456 Count
1777790398	802 Count	608 Count	455 Count
1777789494	800 Count	607 Count	454 Count
1777788590	798 Count	606 Count	453 Count
1777787686	795 Count	604 Count	451 Count
1777786872	793 Count	603 Count	450 Count
1777785969	791 Count	602 Count	449 Count
1777785065	789 Count	601 Count	448 Count
1777784161	787 Count	600 Count	447 Count
1777783257	785 Count	599 Count	446 Count
1777782354	783 Count	598 Count	445 Count
1777781450	781 Count	597 Count	444 Count
1777780546	779 Count	596 Count	443 Count
1777779642	777 Count	595 Count	442 Count
1777778738	775 Count	594 Count	441 Count
1777777835	773 Count	593 Count	440 Count
1777776931	771 Count	592 Count	439 Count
1777776027	769 Count	591 Count	438 Count
1777775123	767 Count	590 Count	437 Count
1777774220	765 Count	589 Count	436 Count
1777773316	763 Count	588 Count	435 Count
1777772412	761 Count	587 Count	434 Count
1777771508	759 Count	586 Count	433 Count
1777770605	757 Count	585 Count	432 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)