EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1764731329	31 Count	229 Count
1764727726	30 Count	219 Count
1764724124	29 Count	209 Count
1764720539	28 Count	200 Count
1764716936	27 Count	189 Count
1764713333	26 Count	181 Count
1764709730	25 Count	168 Count
1764706127	24 Count	159 Count
1764702524	21 Count	152 Count
1764698936	20 Count	142 Count
1764695333	19 Count	132 Count
1764691731	18 Count	124 Count
1764688128	17 Count	86 Count
1764684525	16 Count	78 Count
1764680922	15 Count	72 Count
1764678970	14 Count	72 Count
1764675367	13 Count	70 Count
1764671764	12 Count	68 Count
1764668179	11 Count	66 Count
1764664576	10 Count	59 Count
1764660973	9 Count	57 Count
1764657370	8 Count	55 Count
1764653767	7 Count	24 Count
1764650164	6 Count	20 Count
1764646576	5 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)