EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769975251	301 Count	150 Count	109 Count
1769973447	300 Count	150 Count	109 Count
1769971644	299 Count	149 Count	109 Count
1769969840	298 Count	149 Count	109 Count
1769968036	297 Count	149 Count	109 Count
1769966233	296 Count	149 Count	109 Count
1769964429	295 Count	149 Count	109 Count
1769962625	294 Count	149 Count	109 Count
1769960822	293 Count	148 Count	109 Count
1769959018	292 Count	148 Count	109 Count
1769957214	291 Count	148 Count	109 Count
1769955411	290 Count	148 Count	109 Count
1769953648	285 Count	147 Count	109 Count
1769951845	284 Count	147 Count	109 Count
1769950041	283 Count	146 Count	109 Count
1769948237	282 Count	146 Count	109 Count
1769946434	274 Count	138 Count	102 Count
1769944630	273 Count	138 Count	102 Count
1769942826	264 Count	130 Count	94 Count
1769941023	263 Count	130 Count	94 Count
1769939219	262 Count	129 Count	94 Count
1769937415	261 Count	129 Count	94 Count
1769935612	260 Count	129 Count	94 Count
1769933808	259 Count	129 Count	94 Count
1769932046	254 Count	129 Count	94 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)