EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1756151563	797 Count	739 Count
1756151262	796 Count	738 Count
1756150962	795 Count	738 Count
1756150661	794 Count	738 Count
1756150361	793 Count	737 Count
1756150060	792 Count	737 Count
1756149759	791 Count	737 Count
1756149459	790 Count	736 Count
1756149158	789 Count	736 Count
1756148858	788 Count	736 Count
1756148557	787 Count	735 Count
1756148257	786 Count	735 Count
1756147956	785 Count	735 Count
1756147656	784 Count	734 Count
1756147355	783 Count	734 Count
1756147055	782 Count	734 Count
1756146754	781 Count	733 Count
1756146453	780 Count	733 Count
1756146153	779 Count	733 Count
1756145853	778 Count	732 Count
1756145553	777 Count	732 Count
1756145251	776 Count	732 Count
1756144951	775 Count	731 Count
1756144690	770 Count	731 Count
1756144389	769 Count	731 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)