EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

GW3ATZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GW3ATZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1757256978	296 Count	915 Count	235 Count
1757253369	287 Count	889 Count	228 Count
1757224602	211 Count	676 Count	169 Count
1757220993	201 Count	646 Count	161 Count
1757217384	192 Count	621 Count	154 Count
1757213776	182 Count	589 Count	146 Count
1757210166	172 Count	560 Count	138 Count
1757206557	161 Count	529 Count	129 Count
1757203002	152 Count	495 Count	122 Count
1757199393	142 Count	457 Count	114 Count
1757195784	132 Count	422 Count	106 Count
1757192175	122 Count	390 Count	98 Count
1757188566	112 Count	360 Count	90 Count
1757184958	102 Count	332 Count	82 Count
1757181402	92 Count	305 Count	74 Count
1757177793	82 Count	278 Count	66 Count
1757174185	72 Count	247 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)