EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777805252	584 Count	957 Count	63 Count
1777804652	583 Count	956 Count	63 Count
1777804051	582 Count	955 Count	63 Count
1777803450	581 Count	955 Count	63 Count
1777802853	580 Count	954 Count	63 Count
1777802248	579 Count	953 Count	63 Count
1777801647	578 Count	952 Count	63 Count
1777801046	577 Count	951 Count	63 Count
1777800445	576 Count	950 Count	63 Count
1777799845	575 Count	949 Count	63 Count
1777799244	574 Count	949 Count	63 Count
1777798643	573 Count	944 Count	63 Count
1777798041	572 Count	943 Count	63 Count
1777797440	571 Count	942 Count	63 Count
1777796839	570 Count	941 Count	63 Count
1777796238	569 Count	941 Count	63 Count
1777795638	568 Count	940 Count	63 Count
1777795037	567 Count	940 Count	63 Count
1777794436	566 Count	940 Count	63 Count
1777793835	565 Count	939 Count	63 Count
1777793234	564 Count	939 Count	63 Count
1777792633	563 Count	938 Count	63 Count
1777792033	562 Count	938 Count	63 Count
1777791432	561 Count	938 Count	63 Count
1777790831	560 Count	937 Count	63 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)