EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762248793	960 Count	40 Count	35 Count
1762246992	959 Count	40 Count	35 Count
1762245197	954 Count	40 Count	35 Count
1762239796	951 Count	40 Count	35 Count
1762234394	948 Count	40 Count	35 Count
1762230793	946 Count	40 Count	35 Count
1762227192	944 Count	40 Count	35 Count
1762218195	935 Count	40 Count	35 Count
1762212793	932 Count	40 Count	35 Count
1762209192	930 Count	40 Count	35 Count
1762205591	928 Count	40 Count	35 Count
1762200195	921 Count	40 Count	35 Count
1762196594	919 Count	40 Count	35 Count
1762194793	918 Count	40 Count	35 Count
1762191192	916 Count	40 Count	35 Count
1762183990	912 Count	40 Count	35 Count
1762182189	911 Count	40 Count	35 Count
1762180394	906 Count	40 Count	35 Count
1762178594	905 Count	40 Count	35 Count
1762176793	904 Count	40 Count	35 Count
1762174993	903 Count	40 Count	35 Count
1762171391	901 Count	40 Count	35 Count
1762169591	900 Count	40 Count	35 Count
1762167790	899 Count	40 Count	35 Count
1762165990	898 Count	40 Count	35 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)