EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1752987049	256 Count	201 Count	183 Count
1752985249	253 Count	199 Count	181 Count
1752983448	250 Count	197 Count	179 Count
1752981647	247 Count	195 Count	177 Count
1752979847	244 Count	193 Count	175 Count
1752978046	241 Count	191 Count	173 Count
1752976245	238 Count	189 Count	171 Count
1752974445	235 Count	187 Count	169 Count
1752972644	232 Count	185 Count	167 Count
1752970843	229 Count	183 Count	165 Count
1752969042	226 Count	181 Count	163 Count
1752967242	223 Count	179 Count	161 Count
1752943848	183 Count	151 Count	134 Count
1752942047	180 Count	149 Count	132 Count
1752940247	177 Count	147 Count	130 Count
1752938446	165 Count	136 Count	119 Count
1752936645	164 Count	136 Count	119 Count
1752934844	163 Count	136 Count	119 Count
1752933044	151 Count	125 Count	108 Count
1752931243	148 Count	123 Count	106 Count
1752929442	145 Count	121 Count	104 Count
1752927641	142 Count	119 Count	102 Count
1752925841	134 Count	112 Count	95 Count
1752924040	123 Count	102 Count	85 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)