EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765497455	131 Count	58 Count	15 Count
1765497048	130 Count	58 Count	15 Count
1765495121	127 Count	52 Count	14 Count
1765493195	124 Count	43 Count	13 Count
1765491268	121 Count	36 Count	12 Count
1765489341	118 Count	32 Count	11 Count
1765487414	116 Count	32 Count	11 Count
1765485488	114 Count	31 Count	11 Count
1765483561	110 Count	26 Count	9 Count
1765481634	107 Count	25 Count	8 Count
1765479707	105 Count	21 Count	8 Count
1765477781	102 Count	18 Count	7 Count
1765475854	100 Count	18 Count	7 Count
1765475448	99 Count	18 Count	7 Count
1765473522	96 Count	16 Count	6 Count
1765471595	94 Count	16 Count	6 Count
1765469668	92 Count	16 Count	6 Count
1765467741	90 Count	15 Count	6 Count
1765465815	88 Count	15 Count	6 Count
1765463888	86 Count	15 Count	6 Count
1765461961	84 Count	15 Count	6 Count
1765460034	82 Count	15 Count	6 Count
1765458107	80 Count	15 Count	6 Count
1765456180	78 Count	15 Count	6 Count
1765454253	76 Count	15 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)