EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769960392	124 Count	62 Count	1 Count
1769959491	115 Count	60 Count	0 Count
1769958590	108 Count	55 Count	0 Count
1769957689	102 Count	52 Count	0 Count
1769956789	96 Count	48 Count	0 Count
1769955888	88 Count	46 Count	0 Count
1769954987	83 Count	42 Count	0 Count
1769954086	77 Count	40 Count	0 Count
1769953186	69 Count	36 Count	0 Count
1769952285	63 Count	34 Count	0 Count
1769951384	58 Count	30 Count	0 Count
1769950484	50 Count	27 Count	0 Count
1769949599	45 Count	23 Count	0 Count
1769948699	37 Count	21 Count	0 Count
1769947798	31 Count	17 Count	0 Count
1769946897	24 Count	14 Count	0 Count
1769945997	19 Count	10 Count	0 Count
1769945096	12 Count	7 Count	0 Count
1769944195	5 Count	3 Count	0 Count
1769943294	1002 Count	804 Count	77 Count
1769942394	995 Count	800 Count	77 Count
1769941493	988 Count	797 Count	77 Count
1769940592	982 Count	793 Count	77 Count
1769939692	975 Count	790 Count	77 Count
1769938791	969 Count	786 Count	77 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)