EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1746188852	34 Count	99 Count	33 Count
1746187951	13 Count	40 Count	13 Count
1746187051	364 Count	1033 Count	340 Count
1746186150	355 Count	998 Count	332 Count
1746185250	338 Count	946 Count	316 Count
1746184349	318 Count	882 Count	297 Count
1746183448	297 Count	832 Count	277 Count
1746182548	287 Count	798 Count	268 Count
1746181647	273 Count	758 Count	255 Count
1746180746	255 Count	714 Count	238 Count
1746179846	241 Count	672 Count	225 Count
1746178945	232 Count	644 Count	217 Count
1746178044	219 Count	608 Count	205 Count
1746177143	203 Count	568 Count	190 Count
1746176243	186 Count	519 Count	174 Count
1746175342	179 Count	495 Count	168 Count
1746174442	161 Count	453 Count	151 Count
1746173541	148 Count	413 Count	139 Count
1746172640	134 Count	367 Count	126 Count
1746171740	125 Count	343 Count	118 Count
1746170839	108 Count	302 Count	102 Count
1746169938	81 Count	221 Count	76 Count
1746169038	58 Count	166 Count	54 Count
1746168140	49 Count	139 Count	46 Count
1746167236	34 Count	106 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)