EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1761338679	12 Count	272 Count
1761336879	11 Count	262 Count
1761335078	10 Count	242 Count
1761333277	9 Count	215 Count
1761331486	8 Count	184 Count
1761327884	6 Count	152 Count
1761326083	5 Count	129 Count
1761324282	4 Count	110 Count
1761322482	3 Count	89 Count
1761320681	2 Count	66 Count
1761318880	1 Count	42 Count
1761317079	0 Count	26 Count
1761315278	38 Count	1013 Count
1761313478	37 Count	976 Count
1761309883	35 Count	927 Count
1761308083	34 Count	900 Count
1761306282	33 Count	884 Count
1761304481	32 Count	870 Count
1761302681	31 Count	857 Count
1761300880	30 Count	827 Count
1761299079	29 Count	812 Count
1761297279	28 Count	803 Count
1761295478	27 Count	793 Count
1761293677	26 Count	773 Count
1761291877	25 Count	765 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)