EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8MBR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8MBR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777805255	37 Count	110 Count	36 Count
1777803455	20 Count	57 Count	20 Count
1777801653	381 Count	1064 Count	356 Count
1777799853	355 Count	989 Count	331 Count
1777798052	349 Count	967 Count	326 Count
1777796251	331 Count	916 Count	309 Count
1777792143	257 Count	733 Count	242 Count
1777790343	251 Count	712 Count	237 Count
1777788542	244 Count	690 Count	231 Count
1777786741	219 Count	618 Count	207 Count
1777784940	216 Count	607 Count	205 Count
1777783140	209 Count	583 Count	199 Count
1777781340	201 Count	561 Count	192 Count
1777779977	196 Count	558 Count	192 Count
1777778178	154 Count	450 Count	151 Count
1777776376	117 Count	331 Count	115 Count
1777774575	79 Count	225 Count	78 Count
1777772775	39 Count	108 Count	39 Count
1777770974	376 Count	1086 Count	360 Count
1777769173	342 Count	999 Count	327 Count
1777767373	305 Count	887 Count	291 Count
1777765572	269 Count	785 Count	256 Count
1777763772	230 Count	664 Count	218 Count
1777761978	189 Count	556 Count	182 Count
1777758376	131 Count	392 Count	126 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)