EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777804041	13 Count	168 Count	12 Count
1777802249	6 Count	86 Count	6 Count
1777800449	141 Count	1003 Count	130 Count
1777798648	133 Count	931 Count	123 Count
1777796847	125 Count	878 Count	116 Count
1777795046	118 Count	813 Count	110 Count
1777793245	108 Count	741 Count	101 Count
1777791445	93 Count	679 Count	87 Count
1777789644	82 Count	595 Count	77 Count
1777787843	70 Count	536 Count	66 Count
1777786042	56 Count	436 Count	53 Count
1777784242	38 Count	321 Count	36 Count
1777782441	25 Count	224 Count	24 Count
1777780649	11 Count	111 Count	11 Count
1777778848	152 Count	1046 Count	142 Count
1777777047	139 Count	952 Count	130 Count
1777775247	126 Count	853 Count	118 Count
1777773446	112 Count	750 Count	105 Count
1777771645	102 Count	663 Count	96 Count
1777769844	91 Count	573 Count	86 Count
1777768044	79 Count	493 Count	75 Count
1777766243	65 Count	409 Count	62 Count
1777764442	48 Count	308 Count	46 Count
1777762641	25 Count	196 Count	24 Count
1777760840	12 Count	99 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)