EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2SIX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2SIX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761125504	13 Count	251 Count	13 Count
1761124903	13 Count	248 Count	13 Count
1761123103	13 Count	241 Count	13 Count
1761116502	0 Count	168 Count	0 Count
1761115902	0 Count	165 Count	0 Count
1761114124	0 Count	157 Count	0 Count
1761110501	0 Count	117 Count	0 Count
1761103912	0 Count	94 Count	0 Count
1761103312	0 Count	91 Count	0 Count
1761102712	0 Count	89 Count	0 Count
1761102112	0 Count	86 Count	0 Count
1761101511	0 Count	84 Count	0 Count
1761100916	0 Count	82 Count	0 Count
1761100316	0 Count	78 Count	0 Count
1761099716	0 Count	75 Count	0 Count
1761099116	0 Count	74 Count	0 Count
1761098516	0 Count	70 Count	0 Count
1761097915	0 Count	66 Count	0 Count
1761097315	0 Count	64 Count	0 Count
1761095705	0 Count	54 Count	0 Count
1761094902	0 Count	52 Count	0 Count
1761093715	0 Count	47 Count	0 Count
1761093115	0 Count	43 Count	0 Count
1761092514	0 Count	40 Count	0 Count
1761091914	0 Count	39 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)