EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777795569	50 Count	727 Count
1777793766	49 Count	708 Count
1777791963	48 Count	690 Count
1777790160	47 Count	667 Count
1777788356	46 Count	652 Count
1777786553	45 Count	640 Count
1777784750	44 Count	626 Count
1777782947	43 Count	608 Count
1777781144	42 Count	590 Count
1777779375	37 Count	572 Count
1777777572	36 Count	558 Count
1777775769	35 Count	544 Count
1777773966	34 Count	528 Count
1777772163	33 Count	506 Count
1777770360	32 Count	490 Count
1777768557	31 Count	458 Count
1777766754	30 Count	418 Count
1777764950	29 Count	391 Count
1777763147	28 Count	367 Count
1777761344	27 Count	352 Count
1777759541	26 Count	331 Count
1777757772	21 Count	315 Count
1777755969	20 Count	295 Count
1777754166	19 Count	263 Count
1777752363	18 Count	247 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)