EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IW9GTR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1764822082	153 Count	229 Count	132 Count
1764820873	142 Count	213 Count	123 Count
1764819664	129 Count	193 Count	112 Count
1764818455	112 Count	172 Count	97 Count
1764817247	101 Count	154 Count	88 Count
1764816940	100 Count	154 Count	88 Count
1764815731	81 Count	127 Count	71 Count
1764814522	66 Count	106 Count	58 Count
1764813317	51 Count	85 Count	45 Count
1764812104	33 Count	56 Count	29 Count
1764810895	18 Count	32 Count	16 Count
1764809686	8 Count	12 Count	8 Count
1764808482	680 Count	1000 Count	593 Count
1764807273	665 Count	975 Count	580 Count
1764806060	650 Count	949 Count	567 Count
1764804855	635 Count	921 Count	554 Count
1764803643	624 Count	903 Count	545 Count
1764802438	612 Count	883 Count	535 Count
1764801221	596 Count	856 Count	521 Count
1764800194	583 Count	836 Count	510 Count
1764798981	569 Count	813 Count	498 Count
1764797772	557 Count	792 Count	488 Count
1764796567	542 Count	766 Count	475 Count
1764795354	529 Count	747 Count	464 Count
1764794146	515 Count	723 Count	452 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)