EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SV9KIR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV9KIR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765867063	173 Count	330 Count
1765866160	172 Count	327 Count
1765864425	170 Count	321 Count
1765863522	169 Count	321 Count
1765862619	168 Count	321 Count
1765861716	167 Count	321 Count
1765860813	166 Count	321 Count
1765859910	165 Count	317 Count
1765859007	164 Count	317 Count
1765858104	163 Count	316 Count
1765857201	162 Count	315 Count
1765856298	161 Count	312 Count
1765855395	160 Count	305 Count
1765854492	159 Count	303 Count
1765853589	158 Count	293 Count
1765852686	157 Count	290 Count
1765851783	156 Count	287 Count
1765850880	155 Count	286 Count
1765849977	154 Count	285 Count
1765849074	153 Count	283 Count
1765848171	152 Count	282 Count
1765847268	151 Count	281 Count
1765846366	150 Count	280 Count
1765845463	149 Count	279 Count
1765844560	148 Count	278 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)