EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9SRC-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9SRC-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1755866647	83 Count	678 Count
1755866046	81 Count	665 Count
1755865446	79 Count	649 Count
1755864245	76 Count	611 Count
1755863644	74 Count	598 Count
1755861842	69 Count	530 Count
1755860640	65 Count	509 Count
1755860040	63 Count	501 Count
1755858238	58 Count	478 Count
1755857036	56 Count	430 Count
1755855835	54 Count	389 Count
1755855234	53 Count	366 Count
1755854659	52 Count	355 Count
1755854059	51 Count	345 Count
1755853459	49 Count	337 Count
1755852857	47 Count	324 Count
1755852257	45 Count	313 Count
1755851655	43 Count	302 Count
1755851055	42 Count	293 Count
1755850454	40 Count	279 Count
1755849253	35 Count	265 Count
1755848652	34 Count	255 Count
1755848052	31 Count	240 Count
1755847450	29 Count	234 Count
1755846848	27 Count	225 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)