EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777804967	84 Count	400 Count	57 Count
1777803166	83 Count	400 Count	57 Count
1777801366	82 Count	400 Count	57 Count
1777799565	81 Count	400 Count	57 Count
1777797764	80 Count	399 Count	57 Count
1777764938	60 Count	334 Count	38 Count
1777763122	57 Count	330 Count	36 Count
1777761321	54 Count	325 Count	34 Count
1777759529	51 Count	320 Count	32 Count
1777757728	48 Count	315 Count	30 Count
1777755927	46 Count	308 Count	29 Count
1777754127	44 Count	300 Count	28 Count
1777752326	41 Count	295 Count	26 Count
1777750525	38 Count	287 Count	24 Count
1777748724	34 Count	278 Count	21 Count
1777746924	31 Count	263 Count	19 Count
1777745123	28 Count	249 Count	17 Count
1777743322	25 Count	240 Count	15 Count
1777741521	22 Count	207 Count	13 Count
1777739721	19 Count	177 Count	11 Count
1777737928	16 Count	156 Count	9 Count
1777736128	13 Count	150 Count	7 Count
1777734327	10 Count	131 Count	5 Count
1777732526	8 Count	97 Count	4 Count
1777730725	6 Count	69 Count	3 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)