EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1774079376	34 Count	444 Count	25 Count
1774075775	30 Count	399 Count	22 Count
1774072175	27 Count	356 Count	20 Count
1774068573	23 Count	314 Count	17 Count
1774064972	20 Count	269 Count	15 Count
1774061370	16 Count	224 Count	12 Count
1774057769	13 Count	182 Count	10 Count
1774054168	9 Count	135 Count	7 Count
1774050567	6 Count	89 Count	5 Count
1774046965	2 Count	44 Count	2 Count
1774043364	85 Count	1003 Count	63 Count
1774039764	81 Count	957 Count	60 Count
1774036163	78 Count	922 Count	58 Count
1774032561	74 Count	877 Count	55 Count
1774028960	71 Count	833 Count	53 Count
1774025359	67 Count	785 Count	50 Count
1774021758	64 Count	736 Count	48 Count
1774018157	60 Count	693 Count	45 Count
1774014556	57 Count	650 Count	43 Count
1774010955	53 Count	612 Count	40 Count
1774007353	50 Count	567 Count	38 Count
1774003753	44 Count	531 Count	33 Count
1774000151	41 Count	485 Count	31 Count
1773996549	34 Count	435 Count	25 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)