EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4HSE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757180263	921 Count	814 Count	303 Count
1757178462	919 Count	812 Count	302 Count
1757176662	918 Count	811 Count	302 Count
1757174861	916 Count	809 Count	301 Count
1757173061	915 Count	808 Count	301 Count
1757171260	913 Count	806 Count	300 Count
1757169459	912 Count	805 Count	300 Count
1757165865	905 Count	800 Count	299 Count
1757164065	903 Count	798 Count	298 Count
1757162263	902 Count	797 Count	298 Count
1757160464	900 Count	795 Count	297 Count
1757158662	899 Count	794 Count	297 Count
1757156862	897 Count	792 Count	296 Count
1757155061	896 Count	791 Count	296 Count
1757153260	894 Count	789 Count	295 Count
1757151460	893 Count	788 Count	295 Count
1757149659	891 Count	786 Count	294 Count
1757147859	890 Count	785 Count	294 Count
1757146064	884 Count	781 Count	293 Count
1757144264	883 Count	780 Count	293 Count
1757142463	881 Count	778 Count	292 Count
1757140663	880 Count	777 Count	292 Count
1757138862	878 Count	775 Count	291 Count
1757137061	877 Count	774 Count	291 Count
1757135261	875 Count	772 Count	290 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)