EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ENG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ENG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757155416	190 Count	501 Count
1757154512	189 Count	499 Count
1757153608	188 Count	497 Count
1757152705	187 Count	495 Count
1757152591	186 Count	495 Count
1757151828	185 Count	494 Count
1757150925	184 Count	492 Count
1757150021	183 Count	487 Count
1757149117	182 Count	484 Count
1757148213	181 Count	483 Count
1757147310	180 Count	482 Count
1757146406	179 Count	480 Count
1757145502	178 Count	478 Count
1757144599	177 Count	477 Count
1757143695	176 Count	475 Count
1757142884	175 Count	473 Count
1757141980	174 Count	471 Count
1757141076	173 Count	469 Count
1757140171	172 Count	467 Count
1757139268	171 Count	466 Count
1757138364	170 Count	463 Count
1757137460	169 Count	462 Count
1757136556	168 Count	461 Count
1757135653	167 Count	459 Count
1757134748	166 Count	455 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)