EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ST-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1757179162	72 Count	71 Count	71 Count
1757177481	37 Count	37 Count	37 Count
1757175799	1015 Count	974 Count	974 Count
1757174118	985 Count	945 Count	945 Count
1757172437	963 Count	924 Count	924 Count
1757170756	951 Count	913 Count	913 Count
1757169075	917 Count	880 Count	880 Count
1757167649	887 Count	855 Count	855 Count
1757165968	843 Count	812 Count	812 Count
1757164286	810 Count	780 Count	780 Count
1757162605	768 Count	739 Count	739 Count
1757160924	728 Count	700 Count	700 Count
1757159243	689 Count	662 Count	662 Count
1757157561	647 Count	621 Count	621 Count
1757155880	610 Count	585 Count	585 Count
1757154198	540 Count	516 Count	516 Count
1757152517	495 Count	472 Count	472 Count
1757150836	472 Count	450 Count	450 Count
1757149155	421 Count	400 Count	400 Count
1757147474	387 Count	367 Count	367 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)