EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3OPF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3OPF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1745046993	495 Count	761 Count	316 Count
1745037754	490 Count	761 Count	316 Count
1745037350	478 Count	761 Count	316 Count
1745036450	474 Count	756 Count	313 Count
1745035549	460 Count	743 Count	300 Count
1745033748	456 Count	741 Count	298 Count
1745032847	455 Count	741 Count	298 Count
1745031946	453 Count	738 Count	297 Count
1745031050	450 Count	734 Count	295 Count
1745030148	449 Count	734 Count	295 Count
1745029248	447 Count	732 Count	294 Count
1745028347	445 Count	731 Count	293 Count
1745027461	440 Count	730 Count	293 Count
1745026558	439 Count	730 Count	293 Count
1745025658	437 Count	728 Count	292 Count
1745024761	436 Count	728 Count	292 Count
1745023856	433 Count	724 Count	290 Count
1745022955	431 Count	722 Count	289 Count
1745022054	428 Count	719 Count	287 Count
1745020253	424 Count	715 Count	285 Count
1745019352	422 Count	713 Count	284 Count
1745018451	421 Count	712 Count	284 Count
1745017551	418 Count	709 Count	282 Count
1745016650	416 Count	708 Count	281 Count
1745014849	413 Count	703 Count	280 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)