EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769966343	56 Count	811 Count
1769964539	55 Count	783 Count
1769962736	54 Count	756 Count
1769960932	53 Count	744 Count
1769959129	52 Count	711 Count
1769957326	51 Count	692 Count
1769955522	50 Count	673 Count
1769953719	49 Count	656 Count
1769951916	48 Count	623 Count
1769950152	47 Count	598 Count
1769948349	46 Count	576 Count
1769946545	45 Count	561 Count
1769944742	44 Count	555 Count
1769942939	43 Count	530 Count
1769941135	42 Count	512 Count
1769939332	40 Count	495 Count
1769937529	39 Count	485 Count
1769935725	38 Count	469 Count
1769933922	37 Count	453 Count
1769932119	36 Count	440 Count
1769930315	35 Count	424 Count
1769928552	34 Count	422 Count
1769926749	33 Count	421 Count
1769924945	32 Count	418 Count
1769923142	31 Count	415 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)