EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

2M0SBP-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 2M0SBP-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1757333274	67 Count	431 Count	2 Count
1757331471	66 Count	424 Count	2 Count
1757329668	65 Count	408 Count	2 Count
1757327865	64 Count	401 Count	2 Count
1757326062	63 Count	391 Count	2 Count
1757324296	62 Count	384 Count	2 Count
1757322493	61 Count	377 Count	2 Count
1757320690	60 Count	369 Count	2 Count
1757318887	59 Count	362 Count	2 Count
1757317083	58 Count	355 Count	2 Count
1757315280	57 Count	348 Count	2 Count
1757313477	56 Count	341 Count	2 Count
1757311674	55 Count	334 Count	2 Count
1757309871	54 Count	327 Count	2 Count
1757308068	53 Count	323 Count	2 Count
1757306265	52 Count	318 Count	2 Count
1757304462	51 Count	308 Count	2 Count
1757302697	50 Count	301 Count	2 Count
1757300891	49 Count	294 Count	2 Count
1757299088	48 Count	287 Count	2 Count
1757297285	47 Count	280 Count	2 Count
1757295482	46 Count	273 Count	2 Count
1757293679	45 Count	266 Count	2 Count
1757291876	44 Count	259 Count	2 Count
1757290073	43 Count	252 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)