EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777795214	91 Count	477 Count	87 Count
1777793413	73 Count	371 Count	70 Count
1777791612	52 Count	277 Count	50 Count
1777789812	34 Count	197 Count	33 Count
1777788011	17 Count	113 Count	17 Count
1777786211	222 Count	1064 Count	206 Count
1777784410	203 Count	975 Count	188 Count
1777782609	184 Count	878 Count	170 Count
1777780823	161 Count	782 Count	154 Count
1777779023	138 Count	676 Count	132 Count
1777777222	118 Count	593 Count	113 Count
1777775422	98 Count	491 Count	94 Count
1777773620	79 Count	398 Count	76 Count
1777771819	59 Count	297 Count	57 Count
1777770019	39 Count	201 Count	38 Count
1777768218	18 Count	100 Count	18 Count
1777766418	247 Count	1080 Count	235 Count
1777764617	230 Count	995 Count	219 Count
1777762816	213 Count	920 Count	203 Count
1777761016	194 Count	838 Count	185 Count
1777759217	175 Count	760 Count	167 Count
1777755614	133 Count	586 Count	127 Count
1777753813	114 Count	501 Count	109 Count
1777752012	97 Count	419 Count	93 Count
1777750212	77 Count	330 Count	74 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)