EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773886179	31 Count	259 Count
1773884375	30 Count	250 Count
1773882572	29 Count	242 Count
1773880768	28 Count	229 Count
1773878965	27 Count	217 Count
1773877161	26 Count	206 Count
1773875357	25 Count	197 Count
1773873554	24 Count	186 Count
1773871750	23 Count	179 Count
1773869947	22 Count	168 Count
1773868183	17 Count	160 Count
1773866380	16 Count	147 Count
1773864576	15 Count	136 Count
1773862773	14 Count	123 Count
1773859165	12 Count	104 Count
1773857362	11 Count	91 Count
1773855558	10 Count	79 Count
1773853755	9 Count	71 Count
1773851951	8 Count	57 Count
1773850147	7 Count	47 Count
1773848351	6 Count	34 Count
1773846581	1 Count	23 Count
1773844777	0 Count	10 Count
1773842973	117 Count	1005 Count
1773841169	116 Count	993 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)