EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4GMY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4GMY-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1760414206	101 Count	262 Count	72 Count
1760413306	93 Count	248 Count	65 Count
1760412402	90 Count	241 Count	63 Count
1760411499	86 Count	234 Count	60 Count
1760410592	83 Count	225 Count	58 Count
1760409692	80 Count	216 Count	56 Count
1760408785	76 Count	205 Count	53 Count
1760407882	72 Count	193 Count	50 Count
1760406978	69 Count	184 Count	48 Count
1760406079	66 Count	176 Count	46 Count
1760405176	63 Count	164 Count	44 Count
1760404268	57 Count	149 Count	39 Count
1760403365	53 Count	138 Count	36 Count
1760402540	46 Count	130 Count	34 Count
1760401636	39 Count	116 Count	28 Count
1760400733	35 Count	105 Count	25 Count
1760399834	31 Count	95 Count	22 Count
1760398926	27 Count	86 Count	19 Count
1760398023	23 Count	75 Count	16 Count
1760397120	20 Count	62 Count	14 Count
1760396216	18 Count	56 Count	13 Count
1760395317	16 Count	50 Count	12 Count
1760394414	14 Count	41 Count	11 Count
1760393506	10 Count	30 Count	8 Count
1760392607	6 Count	19 Count	5 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)