EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3KON-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769937930	124 Count	718 Count	63 Count
1769937029	121 Count	701 Count	62 Count
1769936128	111 Count	662 Count	60 Count
1769935226	96 Count	597 Count	54 Count
1769934325	81 Count	552 Count	51 Count
1769933424	78 Count	530 Count	50 Count
1769932523	75 Count	504 Count	48 Count
1769931622	73 Count	474 Count	47 Count
1769930721	70 Count	455 Count	45 Count
1769929820	68 Count	441 Count	44 Count
1769928919	62 Count	414 Count	39 Count
1769928018	60 Count	398 Count	38 Count
1769927117	57 Count	379 Count	36 Count
1769926216	55 Count	364 Count	35 Count
1769925315	52 Count	350 Count	33 Count
1769924414	50 Count	334 Count	32 Count
1769923513	47 Count	311 Count	30 Count
1769922612	45 Count	295 Count	29 Count
1769921711	41 Count	278 Count	26 Count
1769920810	39 Count	259 Count	25 Count
1769919910	36 Count	242 Count	23 Count
1769919033	34 Count	227 Count	22 Count
1769918132	31 Count	207 Count	20 Count
1769917231	29 Count	188 Count	19 Count
1769916330	26 Count	172 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)