EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

ON3RIP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON3RIP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1777791635	897 Count	68 Count
1777790732	874 Count	68 Count
1777789828	850 Count	68 Count
1777788925	829 Count	68 Count
1777788022	805 Count	68 Count
1777787119	783 Count	68 Count
1777786215	760 Count	68 Count
1777785312	743 Count	65 Count
1777784409	726 Count	65 Count
1777783506	706 Count	63 Count
1777782603	685 Count	60 Count
1777781699	668 Count	60 Count
1777780796	646 Count	60 Count
1777779892	630 Count	60 Count
1777778989	607 Count	56 Count
1777778163	587 Count	51 Count
1777777260	567 Count	43 Count
1777776357	547 Count	43 Count
1777775454	527 Count	43 Count
1777774551	509 Count	43 Count
1777773648	489 Count	43 Count
1777772744	471 Count	43 Count
1777771841	451 Count	43 Count
1777770938	432 Count	43 Count
1777770035	410 Count	43 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)