EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1764831287	14 Count	11 Count	11 Count
1764820623	8 Count	7 Count	7 Count
1764817017	1002 Count	704 Count	646 Count
1764815213	998 Count	701 Count	643 Count
1764813441	995 Count	699 Count	641 Count
1764811637	992 Count	697 Count	639 Count
1764809834	989 Count	695 Count	637 Count
1764808031	986 Count	693 Count	635 Count
1764806228	983 Count	691 Count	633 Count
1764804424	979 Count	688 Count	630 Count
1764802621	976 Count	686 Count	628 Count
1764800818	972 Count	683 Count	625 Count
1764799014	969 Count	681 Count	623 Count
1764797211	966 Count	679 Count	621 Count
1764795406	963 Count	676 Count	619 Count
1764793603	960 Count	674 Count	617 Count
1764791843	957 Count	671 Count	615 Count
1764790039	953 Count	667 Count	612 Count
1764788235	950 Count	665 Count	610 Count
1764786432	947 Count	663 Count	608 Count
1764784629	944 Count	660 Count	606 Count
1764782826	941 Count	657 Count	604 Count
1764781022	937 Count	654 Count	601 Count
1764779219	934 Count	652 Count	599 Count
1764777415	930 Count	649 Count	596 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)