EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777818999	571 Count	462 Count	265 Count
1777818399	570 Count	461 Count	265 Count
1777817798	568 Count	460 Count	264 Count
1777817197	566 Count	458 Count	263 Count
1777816597	565 Count	457 Count	263 Count
1777815996	562 Count	455 Count	261 Count
1777815395	560 Count	453 Count	260 Count
1777814795	559 Count	452 Count	260 Count
1777814194	557 Count	451 Count	259 Count
1777813593	555 Count	449 Count	258 Count
1777812993	554 Count	448 Count	258 Count
1777812392	553 Count	448 Count	258 Count
1777811791	551 Count	446 Count	257 Count
1777811191	550 Count	445 Count	257 Count
1777810590	547 Count	443 Count	255 Count
1777809990	545 Count	441 Count	254 Count
1777809389	544 Count	440 Count	254 Count
1777808788	542 Count	439 Count	253 Count
1777808188	540 Count	437 Count	252 Count
1777807587	539 Count	436 Count	252 Count
1777806987	537 Count	435 Count	251 Count
1777806386	535 Count	433 Count	250 Count
1777805785	534 Count	432 Count	250 Count
1777805185	532 Count	431 Count	249 Count
1777804583	529 Count	428 Count	247 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)