EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773882375	174 Count	436 Count	103 Count
1773880574	172 Count	432 Count	102 Count
1773878787	170 Count	426 Count	101 Count
1773876986	168 Count	421 Count	100 Count
1773875185	166 Count	415 Count	99 Count
1773873384	164 Count	411 Count	98 Count
1773871583	162 Count	407 Count	97 Count
1773869782	160 Count	402 Count	96 Count
1773867981	158 Count	397 Count	95 Count
1773866180	156 Count	393 Count	94 Count
1773864379	154 Count	389 Count	93 Count
1773862575	152 Count	384 Count	92 Count
1773860774	150 Count	374 Count	91 Count
1773858973	148 Count	370 Count	90 Count
1773857180	146 Count	365 Count	89 Count
1773855380	129 Count	329 Count	73 Count
1773853579	127 Count	313 Count	72 Count
1773851778	125 Count	308 Count	71 Count
1773849977	123 Count	304 Count	70 Count
1773848177	121 Count	300 Count	69 Count
1773846376	119 Count	296 Count	68 Count
1773844575	117 Count	292 Count	67 Count
1773842775	115 Count	289 Count	66 Count
1773840974	113 Count	286 Count	65 Count
1773839173	111 Count	275 Count	64 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)