EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4HUO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4HUO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1773886199	243 Count	371 Count	130 Count
1773882606	236 Count	363 Count	125 Count
1773879005	231 Count	353 Count	122 Count
1773875403	227 Count	345 Count	120 Count
1773871802	223 Count	336 Count	118 Count
1773868200	219 Count	330 Count	116 Count
1773864599	216 Count	327 Count	115 Count
1773857408	210 Count	315 Count	113 Count
1773853807	208 Count	314 Count	113 Count
1773850205	205 Count	307 Count	112 Count
1773846603	201 Count	301 Count	110 Count
1773843002	197 Count	294 Count	108 Count
1773839405	193 Count	290 Count	106 Count
1773835803	191 Count	285 Count	106 Count
1773832202	188 Count	284 Count	105 Count
1773828600	184 Count	278 Count	103 Count
1773824999	181 Count	273 Count	102 Count
1773821397	177 Count	267 Count	100 Count
1773817804	174 Count	263 Count	99 Count
1773814203	172 Count	262 Count	99 Count
1773810601	169 Count	260 Count	98 Count
1773807000	167 Count	257 Count	98 Count
1773803398	163 Count	252 Count	96 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)