EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762248817	118 Count	569 Count	74 Count
1762247917	116 Count	555 Count	73 Count
1762247016	113 Count	544 Count	71 Count
1762246115	111 Count	526 Count	70 Count
1762245214	108 Count	491 Count	68 Count
1762244314	106 Count	476 Count	67 Count
1762243413	103 Count	467 Count	65 Count
1762242512	101 Count	456 Count	64 Count
1762241611	98 Count	441 Count	62 Count
1762240711	96 Count	429 Count	61 Count
1762239810	93 Count	419 Count	59 Count
1762238909	91 Count	406 Count	58 Count
1762238008	88 Count	391 Count	56 Count
1762237108	86 Count	379 Count	55 Count
1762236207	83 Count	369 Count	53 Count
1762235306	81 Count	353 Count	52 Count
1762234405	74 Count	330 Count	46 Count
1762233505	72 Count	318 Count	45 Count
1762232604	69 Count	310 Count	43 Count
1762231703	67 Count	299 Count	42 Count
1762230802	64 Count	286 Count	40 Count
1762229917	62 Count	277 Count	39 Count
1762229016	59 Count	269 Count	37 Count
1762228115	57 Count	258 Count	36 Count
1762227215	54 Count	249 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)