EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8ULZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8ULZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1764889553	498 Count	68 Count	59 Count
1764887753	497 Count	68 Count	59 Count
1764885951	496 Count	68 Count	59 Count
1764884151	495 Count	68 Count	59 Count
1764882357	490 Count	68 Count	59 Count
1764880557	489 Count	68 Count	59 Count
1764878756	488 Count	68 Count	59 Count
1764876956	487 Count	68 Count	59 Count
1764875154	486 Count	68 Count	59 Count
1764873354	485 Count	68 Count	59 Count
1764871553	484 Count	68 Count	59 Count
1764869753	483 Count	68 Count	59 Count
1764867952	482 Count	68 Count	59 Count
1764866152	481 Count	68 Count	59 Count
1764864351	480 Count	68 Count	59 Count
1764862550	479 Count	68 Count	59 Count
1764860757	474 Count	68 Count	59 Count
1764858956	473 Count	68 Count	59 Count
1764857155	466 Count	62 Count	53 Count
1764855355	458 Count	55 Count	46 Count
1764851754	456 Count	55 Count	46 Count
1764849953	455 Count	55 Count	46 Count
1764848152	454 Count	55 Count	46 Count
1764846351	453 Count	55 Count	46 Count
1764844551	452 Count	55 Count	46 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)