EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3KT-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3KT-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762207677	533 Count	717 Count	369 Count
1762205876	528 Count	712 Count	365 Count
1762204076	523 Count	705 Count	361 Count
1762202275	518 Count	695 Count	357 Count
1762200474	513 Count	689 Count	353 Count
1762198673	508 Count	682 Count	349 Count
1762196873	504 Count	678 Count	346 Count
1762195072	499 Count	667 Count	342 Count
1762193271	494 Count	653 Count	338 Count
1762189674	480 Count	620 Count	330 Count
1762187872	475 Count	600 Count	326 Count
1762186069	473 Count	597 Count	325 Count
1762184268	468 Count	592 Count	321 Count
1762182468	463 Count	586 Count	317 Count
1762180667	458 Count	579 Count	313 Count
1762178866	453 Count	574 Count	309 Count
1762177066	448 Count	569 Count	305 Count
1762175265	443 Count	564 Count	301 Count
1762173464	438 Count	558 Count	297 Count
1762171664	433 Count	553 Count	293 Count
1762169863	428 Count	548 Count	289 Count
1762168075	419 Count	541 Count	285 Count
1762166272	414 Count	536 Count	281 Count
1762164468	409 Count	531 Count	277 Count
1762162667	404 Count	526 Count	273 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)